Introduction:
This is a Digital stopwatch planned explicitly for science
timing, and it can record and review up to nine occasion times. It has two
presentation modes ('Decimal Seconds' and 'MM:SS.SS') and works on a solitary
'AA' antacid battery (included). It additionally has a 'Low Battery' marker.
Specifications:
- Timing Accuracy: 0.01 percent of perusing or 0.005 seconds,
whichever is bigger, +/ - 1 digit.
- view Area: 47 mm by 20 mm.
- Power Requirement: One 'AA' soluble battery.
- Auto-off Feature: Stopwatch shuts down following 1 hour if
inert, or if greatest presentation time is reached (either 99:59:59 or
359999s).
- Battery Life: One years of average use.
- splash resistant
Button function:
Go ahead to turn on the stopwatch. The digital stopwatch turns itself
off naturally if it's inactive for 60 minutes, or if the most extreme showcase
time is reached.
START Clears show to '0.00' and begins timing.
STOP Stops timing and shows recorded time.
RESET Stops timing and resets time to 0.00 seconds.
RESET: (Hold) Stops timing and clears time, last time, and
any put away occasion times.
Occasion While timing, stores occasion times. Occasion:
(Hold) Switches show between 'Decimal Seconds' mode and 'MM:SS.SS' mode.
Review Recalls LAST TIME, or reviews occasions if any
occasions are put away. While seeing occasion times, looks through completely
put away occasions.
1.Hold intends to press-and-hold the conservative for in any
event one second.
2.This capacity is dynamic in all modes aside from while timing.
Timing Event
Timing Events Timing
Basic Intervals With the showcase demonstrating 0.00 second,
press START to begin timing. Press STOP to quit timing and show the time. Press
START again to start timing another stretch. (Note: The presentation will clear
to 0.00 and begin indicating the new time.) Timing at least two spans will make
the past stretch be put away as 'LAST TIME'. After you press STOP, press RECALL
to show the LAST TIME. Press-and-hold RESET to cause the put away LAST TIME
just as the showed chance to be set to zero.
Timing Multiple Events
After you press START to begin timing, press-and-discharge
the EVENT catch to store the recorded time as an 'occasion'. Each time that you
press 'Occasion', the quantity of occasions that have been recorded is shown as
'Occasion N' (where N is the occasion number). Occasion might be squeezed up to
multiple times before timing consequently stops. Something else, press STOP to
quit timing.
Comments
Post a Comment